View Full Version : Float struts for EDO 2000 on PA 18
12-14-2005, 10:46 PM
I'm looking for complete set of struts and ancilliary hardware to mount EDO 2000's onto a PA 18 Experimental Cat. IF anyone has any connections or info leading to aquiring this stuff it would be greatly appreciated.
12-14-2005, 10:50 PM
12-15-2005, 06:42 AM
:crazyeyes: :crazyeyes: :crazyeyes: :crazyeyes: :crazyeyes:
ouch! I bought a set of floats this summer that were in pieces. Of course a few of the parts were not with the floats. The little parts, IE fwd. wire pull fitting were each in the $200 class... for certified.
A bunch of these can be made reasonable enough. The struts can be made from bulk material, then you will need the lower fittings.
I have some blocks of 6061, with access to more if you want to make your own.
12-17-2005, 12:30 AM
Did the looking, fittings are 2024 t-3. More expensive, but available in the proper size to make all of these
Powered by vBulletin® Version 4.2.4 Copyright © 2017 vBulletin Solutions, Inc. All rights reserved.