View Full Version : Airglas Belly Tanks
09-12-2002, 10:45 PM
09-13-2002, 09:08 PM
I am rebuilding a cub with a 32 gallon Airglas belly tank. The Airglass drawings put the pump on the sidewall in the luggage compartment. You then pump fuel into the top of the left hand tank. We put the pump in the underseat storage box with a doubler on the outside. (see photo). It has to be mounted vertically and will not fit under the baggage floor board. The fuel line from the pump to the left hand wing tank on my installation runs back and around the metal headliner. I have seen a tank that Cub Crafters installed and they ran the line up along the front of the rear window. I don't have the drawings in front of me and can't tell you if you can use a T where the sight guage goes into the left hand tank or have to weld in a fitting. You also have to cut a hole in the belly for the plumbing from the tank to the pump. We are going to put an inspection ring there so when the tank is removed all you have to do is replace the inspection plate. I have 2-3 more photos on this and if you want them contact me directly and I will send them attached to an e-mail.
Powered by vBulletin® Version 4.2.0 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.